autocom-cdp-pro-for-trucks-manual-version-1.5 - Car diagnostic tool

More documents

Recommendations

Info

Manual4 Hardware4.1 IntroductionThe diagnostic unit has built-in interfaces for most communications available on the market that are used for OBD(On Board Diagnostic). For certain vehicle models, specific connectors are used for OBD. As accessories there aremany unique cables enabling connection to the car's diagnostic connection.Connection to PC takes place using any of the alternatives USB (Universal Serial Bus) or Bluetooth (wirelesscommunication).4.2 Connections1. Bluetooth antenna2. OBD 16-pin OBD-II connector (SAE J1962)3. Green/Yellow LED Yellow light Indicates communication using USBGreen/Yellow LED Green light Indicates communication using Bluetooth4. Red LED Power5. Green LED Test6. USB-connection for PC1 23 4 5 6www.obd2express.co.uk10
Manual5 Computer configuration5.1 Bluetooth5.1.1 IntroductionTo succeed with the Bluetooth configuration, the Bluetooth card in the computer must be installed correctly andsupport the service Bluetooth SPP – Serial Port Profile (Virtual Comport). 'Bluetooth card' refers to both internalBluetooth cards that, e.g., are found in laptop computers as well as Bluetooth-USB-adapter and other types ofBluetooth cards. NB! For pin code/passkey, only "0" (one zero) shall be used.5.1.2 ConfigurationThe following is a description of Bluetooth configuration. Note that the configuration may vary depending on theBluetooth card in the computer.• Start the Bluetooth manager, usually by choosing Start -> Settings -> Control panel -> Bluetooth.• In the Bluetooth manager, choose to add new unit. Check that the diagnostic unit is connected to a vehicle or othertype of voltage source (power source) before you proceed to search for Bluetooth units.• When the search is finished, a list is shown with the units that were found. Select and choose the diagnostic unityou want to add.www.obd2express.co.uk11
Page 1 and 2: ManualUser manualDiagnostic system
Page 3 and 4: ManualTable of contentsTable of con
Page 5 and 6: ManualThank you for choosing our pr
Page 7 and 8: Manual1.6 WEEE (Waste Electrical an
Page 9: Manual3 Installation3.1 Installatio
Page 13 and 14: Manual6 General use of the program6
Page 15 and 16: Manual7 General functionality7.1 Pr
Page 17 and 18: Manual9 Vehicle choice9.1 Introduct
Page 19 and 20: Manual”Adjust”, and ”Write to
Page 21 and 22: Manual10.4.4 ACT - Component activa
Page 23 and 24: Manual11 Generic OBD11.1 Introducti
Page 25 and 26: Manual11.3.4 Real time parametersHe
Page 27: Manual12 Technical specification•

autocom-cdp-pro-for-trucks-manual-version-1.5 - Car diagnostic tool

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?