TMS2000 - OEC Fluid Handling, Inc.

More documents

Recommendations

Info

INSTRUCTION MANUALTMS2000IMPORTANT SAFETY INFORMATIONThis manual contains instructions for installing electrical hardware in explosionhazard areas.The following warnings must be considered to be in compliance with acceptedcodes.Any inquiries about this manual, or to return defective equipment should bedirected to:PNEUMERCATOR COMPANY120 FINN COURTFARMINGDALE, NY 11735Attention: Technical ServicesTEL: (631) 293-8450FAX: (631) 293-8533TOLL FREE: (800) 209-7858www.pneumercator.comWARNINGInstallation must be in strict accordance with this manual as adopted from thefollowing codes:- ISA RP12.6, "Installation of intrinsically Safe Instrument Systems in Class IHazardous Locations."- UL - Underwriters Laboratories- NFPA 70, "National Electric Code."- NFPA 30A, "Automotive and Marine Service Station Code."FAILURE TO COMPLY MAY RESULT IN PERSONAL INJURY, PROPERTY LOSSAND EQUIPMENT DAMAGE.WARNINGAlteration, modification or replacement with non-factory components couldimpair the intrinsic safety of this equipment, void the warranty and void the ULListing. FAILURE TO COMPLY MAY RESULT IN PERSONAL INJURY,PROPERTY LOSS AND EQUIPMENT DAMAGE.TMS2000 Installation.doc 07-11-05PAGE 1
Liquid Level Control SystemsPAPERFEEDPRINTLEAKSP 1SP 2SP 3WATERTANK IDGROUP IDMODEREVIEW STEPEDITTANKSELECTGROUP SELECTTANK MANAGEMENT SYSTEMTESTEDITGAL%GALULLIN˚FINSTRUCTION MANUALTMS2000SECTION 1 – PRODUCT DESCRIPTIONS1.1 GENERAL SYSTEM OVERVIEWThe TMS2000 is a fully integrated tank monitor system that combines level measurement withprecision in-tank leak detection and external sensors for secondary containment. Figure 1-1 showsa typical block diagram of how a system should be configured for installation. This diagram is not adetailed wiring diagram, which is found in Section 3 of this manual. Figure 1-1 is to guide theinstaller in planning the actual installation, and give a general overview of the possible combinationsof TANKS, LEVEL PROBES, EXTERNAL SENSORS, and OPTIONAL equipment that may berequired for a typical installation. Figure 1-1 shows only one (1) tank with three (3) sensors:however, TMS2000 can monitor up to 2 tanks and 8 sensor combinations. Refer to the specificdesign drawing for the customer's actual site for complete site-specific details on how many tanksand sensors are specified.SEE MANUALSECTION 3.5SEE MANUAL SECTION 2.2PNEUMERCATORTMS 2000DATA DISPLAY /GATHERING &CONTROLEQUIPMENTTMS2000CONSOLECONSOLEOUTPUTSSEE MANUALSECTION 3.4RELAY CONTACTS115/230 VAC(50/60 Hz)POWERMODEM / RS232 / RS485 / RELAY CONTACTSFIELD WIRINGSEEMANUALSECTION 3SENSOR / PROBEINPUTS FROMOTHER TANKSEE MANUALSECTIONS2.3 - 2.8PIPINGSUMPSENSORLEVELPROBEREMOTEMOUNTEDALARMSLIQUID STORAGE TANKFigure 1-1 - Typical System Block DiagramDRAWING NO. 20047 REV. ATMS2000 Installation.doc 07-11-05PAGE 2
Page 1 and 2: Telephone 800-500-9311Telephone 864
Page 3: INSTRUCTION MANUALTMS2000Note: A se
Page 7 and 8: INSTRUCTION MANUALTMS2000The consol
Page 9 and 10: INSTRUCTION MANUALTMS20001.4 LIQUID
Page 11 and 12: INSTRUCTION MANUALTMS2000SECTION 2
Page 13 and 14: INSTRUCTION MANUALTMS20002.3 LEVEL
Page 15 and 16: INSTRUCTION MANUALTMS2000Install th
Page 17 and 18: INSTRUCTION MANUALTMS20002.4.2 BUSH
Page 19 and 20: INSTRUCTION MANUALTMS20004. Tighten
Page 21 and 22: INSTRUCTION MANUALTMS20002.7 LEAK S
Page 23 and 24: INSTRUCTION MANUALTMS20004. Feed th
Page 25 and 26: INSTRUCTION MANUALTMS2000BLK WHTRED
Page 27 and 28: INSTRUCTION MANUALTMS2000CABLE SELE
Page 29 and 30: INSTRUCTION MANUALTMS20003.2 POWER
Page 31 and 32: INSTRUCTION MANUALTMS2000WIRE SPLIC
Page 33 and 34: INSTRUCTION MANUALTMS2000WIRE SPLIC
Page 35 and 36: INSTRUCTION MANUALTMS20003.4 PROGRA
Page 37 and 38: INSTRUCTION MANUALTMS20003.6 PROBE

TMS2000 - OEC Fluid Handling, Inc.

Create successful ePaper yourself

Delete template?

Save as template?