TMS2000 - OEC Fluid Handling, Inc.

GRNINSTRUCTION MANUALTMS20003.3 PROBE/SENSOR WIRING & SPLICES.IMPORTANT! PROBE WIRING INSTRUCTIONS - MODELS TMS2000 AND TMS3000TMS CONSOLETYPICAL WIRING FOR TMS CONSOLES! WARNINGRefer to TMS installation manual forWARNINGS and CAUTIONS beforeproceeding. FAILURE TO COMPLYMAY RESULT IN PERSONAL INJURY,PROPERTY LOSS AND EQUIPMENTDAMAGE.NON-INTRINSICALLY SAFE WIRINGINTRINSICALLY SAFE WIRINGPROBE MODELSCOVERED BY THIS BULLETINMP461SCMP450SMP451SMP452SMP461SVMP462SVMP463SVNON-HAZARDOUS AREAHAZARDOUS AREACLASS 1, GROUPS C,D3/4" NPT (TMS2000)1" NPT (TMS3000)OR EQUIVALENTCONDUIT FITTINGWIRE SPLICE SEAL CONNECTOR (BY PCO *)FOLLOW SUPPLIED WIRE SPLICE INSTRUCTIONSBULLETIN 179; KIT P/N 10585-2 (FOR MP46xS)BULLETIN 181; KIT P/N 10585-2L (FOR MP45xS)1/2" NPT OR EQUIV. CABLE GRIPREQ'D ONLY ON MP45xS MODELS(JUNCTION BOX MOUNTS DIRECTLYTO PROBE ON MP46xS MODELS)REDBLKSHDPROBE 1+VGNDSHIELD+VGNDSHIELDPROBE 2REDBLKSHDTMS2000 PROBE INPUT WIRING TMS3000 PROBE INPUT WIRINGWIRING MUST BE DONE IN WATERTIGHT RATED BOX/HOUSINGCHANNEL1PROBESENSORS+VGNDSHDGNDSIG+V+VFIELD WIRING CABLE (BY CUSTOMER)EXAMPLE: BELDEN 8441, AVAILABLEFROM PCO * AS CW1-0500 (500' SPOOL)12TYPICALTANKW/ PROBEFROMPROBECONDUIT AND VAPOR SEAL FITTING(SIZE AND LOCATION TO BEDETERMINED BY QUALIFIED INSTALLER) REDUCER FITTING(IF NEEDED)BLKJUNCTION BOX(PROVIDED BYINSTALLER)MP46xSMP45xSPNEUMERCATORBulletin 199 Rev. N/C (07/13/05) Liquid Level Control SystemsPage 1 of 1TOREDFIELD CABLENote for all probe models:Conductor colors may varydepending on cable manufacturer.The field cable shield wire mustbe connected to the PROBESHIELD TERMINAL in the consoleI.S. compartment and should be cutback and left unterminated at theprobe junction box.BLKTOWHTTOGNDSTUDTO CONSOLE(AS SHOWN ABOVE)BLKTOBLKTOREDRED* "PCO" REFERS TO PNEUMERCATOR COMPANY.7/13/2005 2:40:12 PM, 1:1, © COPYRIGHT 2005 PNEUMERCATOR COMPANY, INC.Figure 3-4 - MP45xS Cable Splice and WiringTMS2000 Installation.doc 07-11-05PAGE 27