TMS2000 - OEC Fluid Handling, Inc.

INSTRUCTION MANUALTMS20005. Pull properly marked 2 to 4 conductor wiring (depending on probe/sensor configuration) for eachprobe/sensor through the conduit leaving at least 24 inches excess at both console and junctionbox ends for final connections. The field wires must be resistant to hydrocarbon liquids; typeTHHN or MTW, 22 AWG is recommended. Use Belden Cable part number 8441, or equivalent2-conductor shielded cable, for the magnetostrictive probes only. This cable can be supplied byPNEUMERCATOR as part number CW1-0500.6. Fill all conduit VAPOR SEAL-OFF FITTINGS with approved filling compound and tighten allconduit fittings.7. Splice all probe/sensor wires to the respective conduit wires at each WATERTIGHT JUNCTIONBOX. (See Figure 3-4 for a recommended procedure). Maintain correct color-coding and polaritybetween wires.8. Connect probe/sensor wires to the TMS2000 INPUT TERMINALS following Figure 3-1. Maintaincorrect polarity between wires and respective terminal points.9. Probes and sensors should be logically identified as to location and type and recorded on theprobe map provided in this manual, SECTION 3.6.CAUTIONProbe and sensor wires are to be connected ONLY to the designated inputterminals of the INTRINSIC SAFETY compartment. Do NOT allow probe/sensorwires to cross over into the non-intrinsically safe section. FAILURE TOCOMPLY MAY RESULT IN PERSONAL INJURY, PROPERTY LOSS ANDEQUIPMENT DAMAGE.TMS2000 Installation.doc 07-11-05PAGE 25