Network IP Camera - Edimax

More documents

Recommendations

Info

Federal Communication Commission Interference StatementThis equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protectionagainst harmful interference in a residential installation. This equipment generates, uses, andcan radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference byone or more of the following measures:1. Reorient or relocate the receiving antenna.2. Increase the separation between the equipment and receiver.3. Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.4. Consult the dealer or an experienced radio technician for help.FCC CautionThis device and its antenna must not be co-located or operating in conjunction with any otherantenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subjectto the following two conditions: (1) this device may not cause harmful interference, and (2) thisdevice must accept any interference received, including interference that may cause undesiredoperation. Any changes or modifications not expressly approved by the party responsible forcompliance could void the authority to operate equipment.Federal Communications Commission (FCC) Radiation Exposure StatementThis equipment complies with FCC radiation exposure set forth for an uncontrolledenvironment. In order to avoid the possibility of exceeding the FCC radio frequency exposurelimits, human proximity to the antenna shall not be less than 2.5cm (1 inch) during normaloperation.Federal Communications Commission (FCC) RF Exposure RequirementsSAR compliance has been established in the laptop computer(s) configurations with PCMCIAslot on the side near the center, as tested in the application for certification, and can be used inlaptop computer(s) with substantially similar physical dimensions, construction, and electricaland RF characteristics. Use in other devices such as PDAs or lap pads is not authorized. Thistransmitter is restricted for use with the specific antenna tested in the application forcertification. The antenna(s) used for this transmitter must not be co-located or operating inconjunction with any other antenna or transmitter.R&TTE Compliance StatementThis equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEANPARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment and telecommunicationterminal equipment and the mutual recognition of their conformity (R&TTE). The R&TTEDirective repeals and replaces in the directive 98/13/EEC (Telecommunications TerminalEquipment and Satellite Earth Station Equipment) As of April 8, 2000.SafetyThis equipment is designed with the utmost care for the safety of those who install and use it.However, special attention must be paid to the dangers of electric shock and static electricitywhen working with electrical equipment. All guidelines of this and of the computermanufacture must therefore be allowed at all times to ensure the safe use of the equipment.EU Countries Intended for Use67
The ETSI version of this device is intended for home and office use in Austria, Belgium, Bulgaria,Cyprus, Czech, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy,Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia,Slovenia, Spain, Sweden, Turkey, and United Kingdom. The ETSI version of this device is alsoauthorized for use in EFTA member states: Iceland, Liechtenstein, Norway, and Switzerland.EU Countries Not Intended for UseNone68
Page 1 and 2:
VD-233EDUser Manual08-2013 / v1.1
Page 3 and 4:
3-8 PTZ Control ...................
Page 5 and 6:
1.2 Key feature of this network IP
Page 7 and 8:
1.4 Packaging ContentsPlease check
Page 9 and 10:
Rear Cover:56 7,813211104912ItemDes
Page 11:
2-1. Please refer to the definition
Page 14 and 15:
Chapter II Using Network IP Camera
Page 16 and 17:
If you need to change a certain IP
Page 18 and 19: For IE 9:Click ‘Install’ button
Page 20 and 21: NOTE:If this is the first time you
Page 22 and 23: ‘Connect’ buttonIf you want to
Page 24 and 25: 2.4 Client SettingsIn ‘Client Set
Page 26 and 27: Chapter III Advanced ConfigurationI
Page 28 and 29: Daylight SavingKeep the currentdate
Page 30 and 31: Here are the descriptions of every
Page 32 and 33: DHCP IPv4 / IPv6: Obtain both IPv4
Page 34 and 35: 3-3-2 ‘Advanced’ setup pageYou
Page 36 and 37: 3-4 IP FilterWhen this IP camera is
Page 38 and 39: 3-5 VideoYou can adjust the image o
Page 40 and 41: Power LineFrequencyCondition(ABW)WD
Page 42 and 43: 640x480 (VGA)/ 320x240 (QVGA)Frame
Page 44 and 45: Overlayshow certain text / picture
Page 46 and 47: 3-7 MotionThis IP camera is capable
Page 48 and 49: 3-8 PTZ ControlIf you mount the IP
Page 50 and 51: 3-9 EventWhen there’s an event, y
Page 52 and 53: To add a new event, click ‘New’
Page 54 and 55: 3-9-3 Event ServerYou can define th
Page 56 and 57: SMTP ServerCheck this box to enable
Page 58 and 59: 3-10 Recording to Micro SD CardWhen
Page 60 and 61: Set the time range then click “Se
Page 62 and 63: 3-13 Device InfoYou can check the i
Page 64 and 65: SD card deviceUpgradeSD card.Upgrad
Page 66 and 67: Digital I/O User ManualDI/DO connec
Page 70 and 71: EU Declaration of ConformityEnglish
Page 72 and 73: Declaration of ConformityWe, Edimax
Page 74 and 75: TERMS AND CONDITIONS FOR COPYING, D
Page 76: 8. If the distribution and/or use o
show all

Network IP Camera - Edimax

Create successful ePaper yourself

Delete template?

Save as template?