Instruction Sheet 660-510 - S&C Electric Company

CONFIGURING THE COMMUNICATION PROCESSOR MODULE - Continued1step 11You’ll be returned to the “Configure D20” screen.P-NEW-Westronic Inc. Confkquration System 1.10-1parameters are listed in another data table. Access thisdata table by repeating Steps 5 and 6. Using the arrowkeys, scroll through the various tables until you findthe data table with comments relating to communicationparameters. This data table wil be similar tothe one-shown below in “DATA-TAI3LJ3 = 1.”step 12Communication parameters were set at the factory andneed only be accessed to verify that they are corrector to revise the settings from those normally used. TheseI/* ...................................................................... */I*I*I*I*I*I*I*I*I*I*/* Port Configuration Table DefinitionRTS On Delay = 30 msRTS Off Delay = 12 msCharacter to character timeout = 30 msCommunication port timeout = 60 secondsBaud rate = 1200 baudStop bits = 2Parity = None1 Logical RTU defined on this COM portOffset of 0 into the LRU cross reference tableUsing CPM communication port #lI/* ...................................................................... */DATA-TABLE = 2/* LRU Cross Reference Configuration Table6, 0, /* RTU address of LRU , Offset into A009-LRU/* ....................................................................... */A009-CFG.TXT = Insert Wrap: OFF line 157 col 9 =Review the communication parameters. If they areappropriate, press and proceed to Step 13. Ifnot, revise them.To revise a parameter, you’ll once again need to press to change the program from insert modeto overtype mode. Change the parameter as required.Then place the program in edit mode by simultaneouslypressing . Save the change by pressing.*I*I*I*I*I*I*I*I*I*I*I*I*IS&C ELECTRICS&C ELECTRIC CANADAINSTRUCTION SHEET 66@5 1 0Chicago COMPANY Page 7 of 13Toronto LTD.July 20,1992