PN 57.4400.0100_020115 - Genie

10.4 CHANGE ENGINE FUEL FILTERThe engine fuel filter is located on the right side ofengine.Discard the used canister filter and fuel oil in a safeplace and in accordance with local regulation.10.5 CHECK ENGINE GLOW PLUGSThe engine glow plug is located outside the reservoir.Disconnect the glow plug connection. Apply oneprobe of a multimeter, which can check continuity tothe terminal of the glow plug and apply the otherprobe to a suitable ground. If the continuity is correctthe multimeter will give an audible signal. It there isno audible signal, change the glow plug. Repeat thischeck for all of the glow plugs.It is important that only genuine Perkins parts areused. The used of wrong parts could damage thefuel injection equipment.Thoroughly clean the outside surfaces of the fuelfilter assembly. Hold the bottom cover of the filterelement and release the setscrew (1), which is fittedthrough the filter head above the center of theelement. Lower the bottom cover (6) of the filter.Remove the element (4) and discard it. Clean theinside surfaces of the filter head and the cover.Renew the seals (2) and (5) and the o-ring (3) andlightly lubricate them with clean fuel. Put the bottomcover under the new element and hold the elementsquarely to the filter head. Ensure that the elementis fitted in the center against the o-ring in the filterhead. With the assembly in this position, engage andtighten the setscrew. Eliminate the air from the fuelfilter.57.4400.0100 TX51-19M-1-SM 01-29-0289