PN 57.4400.0100_020115 - Genie

10.2 CHANGE ENGINE OIL FILTERDiscard the used canister and lubricating oil in a safeplace and in accordance with local regulation.Some application have a separate filter head that isfitted directly onto the filter mounting face on thecylinder block. The filter canister is then fitted to thefilter head. Follow the procedures below for changingthe oil filter.Put a tray under the filter to retain spilt lubricating oil,clean thoroughly the outside surfaces of the filterassembly. Use a strap wrench or similar tool toloosen the filter canister. Remove and discard thecanister. Ensure that the adapter (1) is secure in thefilter head. Clean inside the filter head. Lubricate theseal (2) on top of the canister with clean enginelubricating oil. Fit the new canister and tighten thecanister a further ½ to ¾ of turn by hand only. Donot use a strap wrench.Do not fill the sump past the “FULL” Mark on thedipstick.Ensure that there is lubricating oil in the sump.Ensure that the engine will not start and operate thestarter motor until oil pressure is obtained. To ensurethat the engine will not start, disconnect theelectrical stop control of the fuel injection pump. Oilpressure is indicated when the warning light isextinguished or by a reading on the gauge. Ensurethe electrical stop control is connected. Start theengine and check for leakage from the filter. Stopthe engine after 15 minutes check the oil level on thedipstick and, if necessary, put more lubricating oilinto the sump.10.3 CHANGE ENGINE AIR FILTERIf working in dusty area remove the filter and dustbowl daily to clean.The air filter is located at rear of engine. Change theengine air filter as following:Shut the engine down and engage the parking brake.Remove the wing nut and air filter cover. Removeinner wing nut and filtering element. Clean the filterbowl. Clean all components using 40 psi pressure.Check for cracks or damage of the elements andreplace if necessary. Apply a small amount ofgrease to the seal. Then refit the element.Reassembly all components.88 TX51-19M-1-SM 01-29-0257.4400.0100