PN 57.4400.0100_020115 - Genie

Section 22Flywheel and Flywheel Housing700 SeriesOperation:Flywheel - to inspect22.02Recommended torque:Engine type Nm lbf ft kgf mSetscrews 100 74 10,2Special notes and tools:Special tools: Retainer (oil tolerant)Warning! The flywheel is very heavy, use lift equipment or get assistancewith the lift operation before removal of the flywheel fasteners.Remove two opposite setscrews from the flywheel and fit temporarily twoguide studs to ensure safety when the flywheel is removed and fitted.Apply Retainer (oil tolerant) to the first three threads of the setscrews.Check the flywheel run-out with a dial test indicator.This must be less than 0,30 mm (0.012 in) totalindicator reading.Check the alignment of the flywheel face.The error in alignment must not be more than0,03 mm (0.001 in) total indicator reading forevery 25 mm (1.0 in) of the flywheel radiusfrom the crankshaft axis to the indicatorplunger. During this operation, keep thecrankshaft pressed toward the front toremove the effect of crankshaft end-float.05/99Printed in England© Propriety information of Perkins Engines Company Limited, all rights reserved14157.4400.0100TX51-19M-1-SM 01-29-02515