PN 57.4400.0100_020115 - Genie

Section 20Fuel System700 SeriesOperation:To record the maximum fuel position of the fuel control rack20.16Recommended torque:Engine type Nm lbf ft kgf m-Special notes and tools:Special tools: Rack position tool, part number 27610089Clamp tool, part number 27161001844. When the end of the clamp is entered far into the timing case,rotate the tool counter-clockwise 90° to engage the lever. Theend of the clamp should now be behind the lever.Tighten the adjustment screw, finger tight, to hold together thetwo levers.55. To ensure that the tool has held both the levers, move the toolbackwards and forwards. The peg on the fuel control rack shouldmove with the tool. Ensure that the sides of the clamp do nottouch the bore.AB66. Remove the spring (A) and then the spring (B)from the peg.Caution: When the spring is disconnected fromthe peg, it is possible for the spring to becomedisconnected from the pin. If this occurs, thespring can fall into the sump!05/99Printed in England© Propriety information of Perkins Engines Company Limited, all rights reserved128502 51-19M-1-SM 01-29-02 57.4400.0100