PN 57.4400.0100_020115 - Genie

Section 20Fuel System700 SeriesOperation:Fuel injection pump - to remove and to fit20.08Recommended torque:Engine type Nm lbf ft kgf mFuel pipes 20 15 2,0.Service operations1. Remove high pressure fuel pipes 20.032. Remove electrical stop solenoid 23.06Special notes and tools:Cautions: Clean around the edges of the fuel injection pump before it isremoved to prevent dirt from entering the inside of the engine.Use a separate spanner to prevent movement of the outlets of the fuelinjection pump when the high-pressure pipes are released or tightened.Release the union nuts of the high-pressure pipes from the atomisers andfuel injection pump and remove the pipes. Do not bend the pipes.Remove the support bracket / blanking plate from the side of the cylinderblock. Record the position of the four setscrews, because on some earlierengines, they are of different lengths.AS HGJDD 19991 SDFDFUEL PUMPIDENTIFICATION PLATE05/99Printed in England© Propriety information of Perkins Engines Company Limited, all rights reserved492 51-19M-1-SM 01-29-02 57.4400.0100118