PN 57.4400.0100_020115 - Genie

Section 19Lubrication System700 SeriesOperation:Oil filter canister - to renewRecommended torque:Engine type Nm lbf ft kgf m-Special notes and tools:Special tools: Strap wrench (or similar tool)19.01Warning! Discard the used canister and lubricating oil in a safe place and inaccordance with local regulations.Any excess lubricating oil must be drained to the correct level.An excess of lubricating oil could enter the breather valve.This could causethe engine speed to increase rapidly without control.Cautions: Ensure that the application is on a level surface to ensure anaccurate reading on the dipstick. When the sump is filled with lubricating oil,ensure that the level of the oil is not above the notch on the dipstick.Note: Some engines have a separate filter head that is fitted to the cylinderblock, directly onto the filter mounting face. The filter canister is then fitted tothe filter head.Remove and discard the canister. Ensure that the adaptor is secure in the filter head.Fit the new canister and tighten by hand until the seal contacts the filter head, or the mounting face. Tighten the canister a further1/2 to 3/4 of a turn by hand only. Do not use a strap wrench.05/99Printed in England© Propriety information of Perkins Engines Company Limited, all rights reserved10357.4400.0100TX51-19M-1-SM 01-29-02477