PN 57.4400.0100_020115 - Genie

Section 14Crankshaft Assembly700 SeriesOperation:Crankshaft - to fitRecommended torque:Engine type Nm lbf ft kgf mBearing caps 147 108 15,014.12Special notes and tools:Note: Before the front and rear bearing caps are fully tightened, use a straightedge to check their alignment with the front / rear faces of the cylinder block.Caution: After the crankshaft has been overhauled, it must be thoroughlycleaned and the oil holes inspected for debris.After the rear cap has been tightened, it is important to remove any sealantfrom inside the recess for the rear oil seal. If this is not done, the oil seal willnot fit correctly and will cause oil leakage.1234Apply a small amount of silicone adhesive, part number 21826038to the corners of the cylinder block for the rear main bearing cap.(See caution above.)05/99Printed in England© Propriety information of Perkins Engines Company Limited, all rights reserved74448 51-19M-1-SM 01-29-02 57.4400.0100