PN 57.4400.0100_020115 - Genie

Section 14Crankshaft Assembly700 SeriesOperation:Crankshaft pulley - to remove and to fit14.01Recommended torque:Engine type Nm lbf ft kgf mSetscrews 185 136 19,0Special notes:Note: Some applications have an axial power take-off that is driven off thecrankshaft pulley. The crankshaft pulley, on these applications, is retainedby a retainer (B) as well as a washer and setscrew.If an axial power take-off is used, it will be necessary to use an extractor toremove the crankshaft pulley.Lock the crankshaft to prevent its counter-clockwise movement.Caution: Remove the device used to lock the crankshaft.Note: If the surface for the oil seal is damaged or there is a deep groove thatis caused by the oil seal, it may be possible to fit a wear sleeve, operation14.02.AA. Silicon sealant;All engines without axial power take-off.B. For axial power take-off variants only(no silicon sealant is required).BApply a thin continuous 360° bead of loctite 648 approximately 6 mm (0.23 in) beyond the chamfer on the recess in the crankshaftpulley (B). The bead should also be applied to the keyway. Apply only sufficient loctite to ensure that the bead will spread to give a6 mm wide bead when the pulley is fitted. Allow 4 hours before the power take off is used, to ensure that the loctite is dry. Fullstrength is obtained in 24 hours.05/99Printed in England© Propriety information of Perkins Engines Company Limited, all rights reserved6357.4400.0100TX51-19M-1-SM 01-29-02437