PN 57.4400.0100_020115 - Genie

8. Use a screwdriver or a 7 mm wrench,loosen the hose-clamps of the air filtersleeve; and then disconnect the air filter.09. Tag and disconnect the electrical wires.10. Tag and disconnect the two drains of thehydraulic pump with a 32 mm wrench.11. Using a 46 mm wrench disconnect theintake line of the hydraulic pump.12. Using an 18 mm wrench, disconnect thesupply hose and use 8 mm wrench todisconnect the two pressure lines of thehydraulic pump.13. Tag and disconnect the pressure and intakeline on the distribution.14. Tag and disconnect the two hoses one thewater-oil radiator by using a 32 mm wrench.15. Remove the four screws of the front andback vibration supports with a 22 mmwrench.4. Connect the pressure and intake line on thedistribution.5. Using an 18 mm wrench, connect thesupply hose and use 8 mm wrench toconnect the two pressure lines of thehydraulic pump.6. Using a 46 mm wrench connect the intakeline of the hydraulic pump.7. Connect the two drains of the hydraulicpump with a 32 mm wrench.8. Connect the electrical wires.9. Use a screwdriver or a 7 mm wrench,tighten the hose-clamps of the air filtersleeve; and then disconnect the air filter.10. Connect the flexible pipe of the mufflerloosening the clamps with a 10 mm wrench.16. Using adequate lifting device sling theengine, make sure no parts are stillconnecting the engine to the machine.17. Lift and remove the engine from themachine, rest it on a suitable support andsecure it in position.INSTALLATIONFollow the procedures below for the installationof the engine:11. Connect the filler extension of the oil tankusing a 19 mm and 10 mm wrench.12. Open the oil tank valves.1. Install the engine in the machine.2. Install the four screws of the front and backvibration supports with a 22 mm wrench.3. Connect the two hoses on the water – oilradiator by using a 32 mm wrench.DO NOT DISASSEMBLE ANY COMPONENT (S) DURING WARRENTY PERIOD WITHOUT CONTACTING TEREXLIFT.328 TX51-19M-1-SM 01-29-02 57.4400.0100