PN 57.4400.0100_020115 - Genie

RE 90302-02-B/05.94A4V/DA-A6V/ DA InstallationChecking settings (start of control)Notes on settingObserve safety regulations!All settings to conform to works orderBlocked state ("road" gear and fully braked)Pressure gauge to be connected at 400 bar to G 1 and G 2Start of control: (see works order)Pressure gauge at G 1 = operating pressurePressure gauge at G 2 = set pressureExample:Start of control 200 barIncrease operating pressure slowly until pressure gaugeG 1 reaches 200 barAt the operating pressure, reading pressure gauge G 2,approx. 1 /3 of operating pressure should be present i.e.a set pressure of approx. 70 bar."This is start of control"Set pressure adjustment at the setscrew - start of controlNote:Rotate in clockwise direction - start of control fallsIn installations with two or more motors e.g. trackedvehicles the following setting may also be used:Destroy safety cap at Q min stopLoosen lock nutDo not permit setting screw Q min to turnConnect operating pressure gauge to G 1Example:Increase operating pressure slowly until pressure gauge atG 1 shows 200 barCheck: Q min setscrew is "secure" (control lens is pressedagainst setting screw).After 200 bar operating pressure the screw becomes loose(control lens oscillates in Q max direction)"This is the start of control"NBDo not alter set value Q min screwNote:Adjustment at start of control setting screwNote:After checking or setting operations start of controladjustment screws and adjustment screw Q min should befitted with new safety caps.Original HYDROMATIK caps yellow -equipment manufacturers caps are orange12 Brueninghaus Hydromatik320 51-19M-1-SM 01-29-02 57.4400.0100