PN 57.4400.0100_020115 - Genie

16.1 REAR AXLEREMOVAL / INSTALLATION8. Remove the load cell pin by using a slidehammer.REMOVALTo remove the rear axle from the machine,proceed as follows:1. Remove all attachments such as fork orbucket.2. Remove the differential drain plug and drainthe oil.3. Raise the tires off the ground by using alifting device. Lower the machine ontowooden blocking to support the chassis.Place additional support under the engineside of the chassis to prevent side tipping.4. Remove the drive line extension and driveline.9. Slowly lower the axle approximately sixinches and stop.10. Tag and disconnect the axle vent hose.ATTENTIONMake a thorough visual inspection of the areaaround the axle to make sure that all hydraulicand electric lines are clear of the axle.11. Place a suitable jack under the axle to preventthe axle from moving while the mountinghardware is being removed.5. Remove the rear wheels.6. Tag and disconnect the hoses from thesteering cylinder (#1 and #2). Place capsand covers on the hydraulic lines andcylinders to prevent hydraulic contamination.12. Remove the mounting bolts/ pivoting pin,which secure the axle to the frame.13. Lift the axle using a suitable sling and liftingdevice, and move it to a suitable work area.REAR AXLE INSTALLATIONTo install the rear axle on the machine, proceedas follows:7. Place a suitable jack under the axle toprevent the axle from moving while themounting hardware is being removed.1. Raise axle approximately six inches toreconnect the vent hose.2. Connect the axle vent hose.DO NOT DISASSEMBLE ANY COMPONENT (S) DURING WARRENTY PERIOD WITHOUT CONTACTING TEREXLIFT.57.4400.0100 TX51-19M-1-SM 01-29-02143