PN 57.4400.0100_020115 - Genie

Do not use steel hammer or pinch bar. These itemscan cause damage to the machine parts.19. Remove pivot pin from the cassis hole. Ifnecessary strike the pivot pin by using a lead orbrass hammer. Do not use steel hammer or pinchbar.20. Lower the boom until the cylinder rests on thesupporting blocking or stand.The weight of the boom assembly is approximately1600 lbs; weight of hoist cylinder is approximately 170lbs. Use adequate lifting equipment to support theboom assembly and cylinders. Failure to follow thiswarning could cause serious injury to personnel ordamage to the machine.3. Apply antisize to the pivot pin and install pin throughthe cassis hole.4. Using two 19 mm wrenches install the retainingbolt to the lower boom hoist cylinder.5. Using adequate lifting device, lower the boom andinstall the rod end pin of boom hoist cylinder toboom base.6. Install retaining bolt securing the rod pin to theboom.21. Remove the sling securing the cylinder to theboom, then raise the boom until the boom hoistcylinder can be removed.22. Using adequate lifting device remove the cylinderfrom the machine and support it on stands toprevent serious injury or damage to machine.7. Install compensation cylinder to boom base.INSTALLATIONFollow the procedures list below to install the boomhoist cylinder.1. Position the machine on a hard level surface.2. Using adequate lifting device lift the boom hoistcylinder and place it in position.DO NOT DISASSEMBLE ANY COMPONENT (S) DURING WARRENTY PERIOD WITHOUT CONTACTING TEREXLIFT.134 TX51-19M-1-SM 01-29-0257.4400.0100