PN 57.4400.0100_020115 - Genie

15.5 COMPENSATION CYLINDERREMOVAL / INSTALLATIONREMOVALFollow the procedures below for removal ofCompensation Cylinder:1. Position the machine on a hard level surface.2. Remove all attachments from attachment holdingframe (refer to section 14.3 Attachment Removal).5. Raise the boom to the maximum height.6. Place a container of suitable size under thehydraulic piping before disconnecting the hoses.7. Using a 27mm wrench tag and disconnect thehydraulic hoses from the holding valves.Install covers and plugs on the lines and ports toprevent the entry of contaminants.8. With suitable lifting device secure the rod end ofthe compensation cylinder.3. Using two 13 mm wrenches remove retaining boltfrom pivot pin.9. Remove the retaining bolt from the lower pivot pin.10. Remove the lower pivot pin.11. Using suitable lifting device remove cylinder fromthe machine.Do not use steel hammer or pinch bar. These itemscan cause damage to machine parts.4. Remove pivot pin. If necessary use a lead or brasshammer strike the pivot pin. Do not use a steelhammer or pinch bar.ASSEMBLY1. Position the machine on a hard level surface.2. Using suitable lifting device apply sling to the rodend of the cylinder.DO NOT DISASSEMBLE ANY COMPONENT (S) DURING WARRENTY PERIOD WITHOUT CONTACTING TEREXLIFT.57.4400.0100TX51-19M-1-SM 01-29-02 129