PN 57.4400.0100_020115 - Genie

14.9 FUEL TANKDISASSEMBLYFollow the procedures listed below for removing thefuel tank:1. Position the machine on a hard level surface.ASSEMBLYFollow the procedures listed below for installing thefuel tank:1. Install the three attaching screws to secure thefuel tank.2. Connect the electrical fuel gauge.3. Connect the fuel supply and return lines. Tightenthe hose clamps.The weight of the counterweight is approximately2150 lbs. Use adequate lifting equipment to supportthe counterweight. Failure to follow this warningcould cause serious injury to personnel or damage tothe machine.2. Use an adequate lifting device to support thecounterweight.3. Remove the four bolts (two on the side and twoon the back).4. Lower the counterweight from the machine.5. Carefully clean around the drain plug of the fueltank.6. Place a suitable container under fuel tank fordraining fuel.7. Remove fuel tank drain plug and fuller cap,allowing fuel to drain completely.8. Use a screwdriver to loosen the hose clampsand disconnect the fuel supply and return lines.9. Disconnect the electrical fuel gauge.10. Use wood blocking to support the fuel tank.11. Using a 13 mm and 19 mm wrench remove thethree screws attaching fuel tank to the frame.4. Install the fuel tank drain plug.5. Fill the tank and replace the fuel cap.The weight of the counterweight is approximately2150 lbs. Use adequate lifting equipment to supportthe counterweight. Failure to follow this warningcould cause serious injury to personnel or damage tothe machine.6. Use an adequate lifting device, install thecounterweight.7. Install the four bolts (two on the side and two onthe back). Check for leaks.14.10 OIL TANKDISASSEMBLYFollow the procedures listed below to disassemblythe oil tank.1. Remove the drive shaft protection cover by usinga 13 mm wrench to loosen the four lockingscrews.12. Lower and rest the fuel tank on the ground.57.4400.0100TX51-19M-1-SM 01-29-02115