PN 57.4400.0100_020115 - Genie

14.7 PROXIMITY SWITCHADJUSTMENTIn case of a failure or complete malfunctioning of theproximity switches due to a loosening of their fixingring nuts, re-adjust their position:1. Loosen nuts (A) fixing the proximity switch (B).2. Set the mobile part C of the machine, controlledby the proximity switch, as close as possible toit. Near the proximity switch to the componentuntil the LED indicator D lights up.14.8 DRIVE SHAFTThis section contains instructions for removing andrepairing these drive shafts.DISASSEMBLYPeriodic inspections of the drive shafts arerecommended to check for proper lubrication,excessive wear, and any loose, missing or damagedcomponents.3. Near the proximity switch by other 1/8". Tightenthe proximity switch fitting nut at a torque of 15Nm and the relevant lock nut.The machine is equipped with a proximity switch onthe parking brake. This switch prevents the machinestarting when the parking brake is not engaged.Prior to removing the drive shaft, support the driveshaft to prevent it from dropping. Block the wheelsto prevent the machine from rolling.To remove the drive shaft follow the procedures listedbelow:1. Position machine on a hard level surface.2. Block all wheels to prevent machine from rolling.3. Using a 13 mm wrench, remove the four boltsfrom the bottom protection cover.57.4400.0100TX51-19M-1-SM 01-29-02113