Global Service Way - Technical Information

Recommendations

Info

4. Apply primer ( Zinc spray).1) Sufficiently apply primer on the welded areas(K) of the right and left rear of left upper armsbrackets.NOTEIt takes 5 minutes for primer to dry.2) Sufficiently apply primer/zinc spray on thedifferential housing (L) of the axle casing on therubbed down areas.3) Sufficiently apply primer into the space (M)between the lower arm mounting and rear axlecasing on both sides.
4. Apply undercoating.CAUTIONMake sure to use one can of undercoating pervehicle.1) Sufficiently spray undercoating on the outsideof the left rear upper arm bracket (N).2) Spray undercoating on the inside of the leftrear upper arm bracket through the upper armbracket holes (O).3) Repeat step 1) and 2) for the right rearupper arm bracket.4) Spray undercoating on the rear axle casing (P)throughout as shown in photo.
Page 1: TSBLocalSubjectRear Upper Arm Brack
Page 4 and 5: 3.Check the thickness of the upper
Page 6 and 7: 3) Use an air blow gun to blow off
Page 10: 5. Reinstall the lateral rod.Tighte

Global Service Way - Technical Information

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?