Global Service Way - Technical Information

ePAPER READ

DOWNLOAD ePAPER

smartdata.plus.com

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

START NOW

5) Using a magnetic stick (H) remove rust insidethe left rear upper arm bracket.6) Using an air blow gun (J) remove rustand debris from inside the left rear upper armbracket.3. Repeat steps 4) through 6) for the rightrear upper arm bracket.

Recommendations
Info

3) Use an air blow gun to blow off debris and dirtfrom around these areas.4) Drill holes (G) 10mm in diameter on the lower of the rear side of the left rear upper arm bracket as indicatedin the below picture.CAUTIONBe careful not to damage the rear axle casing.# The position of holes on the rear upper arm bracketFrontRearRearFrontFrontRearRearFront

Page 1: TSBLocalSubjectRear Upper Arm Brack
Page 4 and 5: 3.Check the thickness of the upper
Page 8 and 9: 4. Apply primer ( Zinc spray).1) Su
Page 10: 5. Reinstall the lateral rod.Tighte

Global Service Way - Technical Information

Create successful ePaper yourself

Delete template?

Save as template?