Washington Works - DuPont

More documents

Recommendations

Info

Contract Administration Initiated: 07/1992 CAG-07Site Conditions SC1 Revised: 05/2013 Monitor: John SorokaRetention: 3 yrs after obsolete or superseded Revision Due: 10/2015 Page 22record signed by a responsible agent of your company. “Examples” of specific work tasks arelisted below, but are not limited to:Welding, Confined Space Entry, Crane Operation, HPWC, NDT(See Section 11 for additional work tasks)Current welder and crane operator certification, with proof of identification, is required for thespecific piece of equipment being used. Proof of a current annual physical for crane operatorsshall also be provided.2.5 Welding Specific TrainingAll users of oxy-fuel burning equipment shall be trained in safe operating techniques and theelectrical hazards of welding. Proof of training must be provided prior to the start of the work.3 FIRE PROTECTION3.1 ProceduresContractor shall observe the Washington Works fume release, fire, and disaster responseprocedures. The contractor’s job supervisor will be given a copy of and be oriented by thedesignated DuPont representative on the proper response to all fire and fume alarms as well asplant evacuation procedures in the event of an onsite disaster or other significant emergency event.The contractor’s on-site supervisor shall ensure that all of the contractors’ employees arethoroughly familiar with those procedures. Contractor will be reimbursed on a time-and-materialbasis for lost time resulting from evacuations due to fume release and fire or disaster drills.3.2 SmokingSmoking will be permitted only in areas designated by DuPont. All smoking materials shall becarried in plastic bags or containers while performing work in the Teflon® production areas atWashington Works and the employees must thoroughly wash their hands before handling anysmoking products.Smoking by a Contractor employee in any no designated area shall be considered cause to requirethe Contractor to remove that employee from the plant site immediately.3.3 “Strike Anywhere” Matches“Strike Anywhere” matches are not permitted on the Plant.3.4 Flammable MaterialsStorage and use of flammable materials will be subject to the approval of DuPont. Safety cabinetsand cans shall be used for storage and dispensing flammable liquids and must have prior approvalof DuPont. Gasoline powered tools or equipment are not permitted to be stored or operated insidebuildings without prior approval.Flammable liquids (including gasoline, diesel, etc.) in quantities greater than five (5) gallons shallbe stored and transported in Department of Transportation (DOT) approved containers. Properidentifying placards shall be displayed on these containers.Copyright © 2012 E. I. du Pont de Nemours and Company. All rights reserved
Contract Administration Initiated: 07/1992 CAG-07Site Conditions SC1 Revised: 05/2013 Monitor: John SorokaRetention: 3 yrs after obsolete or superseded Revision Due: 10/2015 Page 233.5 Fire ExtinguishersContractor shall furnish a sufficient number of the proper type of fire extinguishers to protect itswork area and extinguish any fire that may result in the performance of its work.3.6 Oily Rag StorageDirty and oily used rags shall be kept in fireproof metal containers with self closing lids. Contactthe Contractor Environmental Coordinator at 304-863-4463 for instructions on disposal.3.7 Protective StructuresAny plastic, tarpaulin, or other material used to construct a hut, tent, or similar protective structureshall be flame retardant.3.8 Burning and Welding EquipmentThe use of acetylene will not be permitted on this site due to its highly explosive characteristics.In lieu of acetylene, the use of MAPP, propylene, propane or natural gas is acceptable. Allcylinders must be capped when not in use and secured at all times.All oxy-fuel burning and welding units shall be equipped with combination flashback arrestorsand check valves between the torch AND on the hoses at the regulator.All users of oxy-fuel burning and welding equipment shall be trained in safe operating techniques.One portable fire extinguisher having a rating of not less than 2-A:20-B:C shall be kept at eachlocation where welding or cutting is to be performed.4 CONSTRUCTION FACILITIES4.1 Identification (if applicable)Contractor shall post a sign of a size and character consistent with the size, nature and duration ofthe contract, identifying its site headquarters, which may be an office, trailer, toolbox, or storagearea.4.2 ParkingContractor’s employees shall park in the designated construction parking area only. First timeviolators will be towed at the contractor employee’s expense; Second time violators will be towedat the contractor’s expense.4.3 Site AccessNormal site working hours are 6:30 a.m. to 5:00 p.m., Monday through Friday. Entry and exit atall times shall be through the designated gate.Contractor employees shall be confined to a specific work area. Designated routes will beestablished for access to the work area and for movement of material and equipment. Movementof material and equipment shall be scheduled with DuPont.4.4 Contractor VehiclesAll contractor vehicles must have some type of identification indicating the company that theybelong to. This identification must be visible on both sides and can be magnetic or painted. ThisCopyright © 2012 E. I. du Pont de Nemours and Company. All rights reserved
Page 1 and 2: Contract Administration Initiated:
Page 21: Contract Administration Initiated:
Page 39: Contract Administration Initiated:

Washington Works - DuPont

Create successful ePaper yourself

Delete template?

Save as template?