TR Instruction Manual - Dover Flexo Electronics, Inc

5. All eight wires must go thru the black plastic protective tube. The technique that works the best isto first twist all of the bare conductors together at the ends, only, and run the wires thru the slot.Then put the plastic tube over the wires and push it into the slot, under the beam and out past theshaft clamp. The wires act as a guide for the tube.6. The roll must only be installed with the identified end (refer to Section 4.3.3, Step 2) at theelectrical connector block which is at the slot end of the shaft.7. When installing the end cover (where the decal is located) observe the two small holes in the shaft.These are for the set screws in the end cover which must be positioned so the screws go into theholes. Otherwise, the Tension Force direction will be wrong.8. Use the procedure in Section 4.3.2, Steps 3, 4, and 5 above when installing the electrical connector.If you encounter any difficulties or have any questions regarding disassembly or reassembly of the TRtransducer, please call DOVER FLEXO ELECTRONICS and ask for the Technical ServiceDepartment.16