CYLINDER HEAD (4A–FE) - CelicaTech

ENGINE MECHANICAL–Cylinder Head (4A–FE)EM–113(c) Install the water inlet and inlet housing assemblywith the bolt and two nuts.Torque: 20 N–m (200 kgf–cm, 14 ft–lbf)(d) Connect the following hoses: ,(1) Lower radiator hose(2) Water inlet pipe hose(3) Auxiliary air valve water by–pass hose(4) Heater water hose(5) EVAP BVSV vacuum hose (from port P ofthrottle body)(6) EVAP BVSV vacuum hose (from charcoal canister)(e) Connect the following connectors:• Water temperature sender gauge connector• Water temperature sensor connector24. INSTALL WATER OUTLET(a) Remove any old packing (FIPG) material and becareful not to drop any oil on the contact surfaces ofthe water outlet and cylinder head.• Using a razor blade and gasket scraper, remove allthe oil packing (FIPG) material from the gasketsurfaces and sealing groove.• Thoroughly clean all components to remove allthe loose material.• Using a non–residue, clean both sealing surfaces.(b) Apply seal packing to the water outlet groove.Seal packing: Part No. 08826–00100 or equivalent• Install a nozzle that has been cut to a 2 – 3 mm(0.08 – 0.12 in.) opening.HINT: Avoid applying an excessive amount to the surface.• Parts must be assembled within 15 minutes ofapplication. Otherwise the material must be removedand reapplied.• Immediately remove nozzle from the tube and reinstallcap.(c) Install the water outlet with the two bolts.Torque: 15 N–m (150 kgf–cm, 11 ft–lbf)(d) Connect the upper radiator hose to the water outlet.