GPS Plus Collar Manager - Vectronic Aerospace GmbH

Doc. No.: GPS Plus Collar Manager
Date: 7.3.12
VECTRONIC Aerospace
4.4.3.9 GSM Destination Address (GSM collars only)
This command allows you to change the destination address of a GSM collar. This is the
phone number to which the collar will send its SMS messages. The form (Figure 84) consists
of two parts. The upper part gives the ID and current Destination Address. You cannot After
entering the new number, click on Transmit to send the new number to the collar. You will
receive an acknowledgement message when operation was successful.
Figure 84: Configure Destination Address directly in the collar
4.4.3.10 SMS Reception Delay (GSM collars only)
By default, the collar’s GSM modem will switch on to send an SMS, listen to incoming
messages immediately after all SMS have been sent, and switch off again. To increase the
chance that the collar can receive new schedules or commands in real time, immediately after
it has transmitted the GPS location, you can delay the interval for SMS reception. You can
change the SMS Reception Delay in steps of eight seconds. The modem will stay switched on
for this time to listen. Please note that the SMS reception delay will shorten the lifetime of
your collar.
Figure 85: Configuration of SMS Reception Delay
4.4.3.11 Argos Transmitter
Configuring the Argos transmitter includes the following values:
Argos Channel: This is the frequency of your collar’s Argos transmitter for location and
transmission services via Argos. The frequency is provided by Argos.
Argos ID: This is the hexadecimal identification code of your collars Argos transmitter.
Everywhere else in the program the decimal ID code is used. It is provided by Argos.
This design is the property of VECTRONIC Aerospace GmbH. Unauthorized duplication or distribution to a third party is prohibited.
VECTRONIC Aerospace 98 /235 Manual_GPS-Plus-Collar-Manager-V3.11.3.docx