GPS Plus Collar Manager - Vectronic Aerospace GmbH

Doc. No.: GPS Plus Collar Manager
Date: 7.3.12
VECTRONIC Aerospace
5.3.6.9 Proximity Schedule Disable (UHF collars only)
This command allows you to disable a GPS proximity schedule stored on a collar. To enable
the proximity schedule again, you need to send a new proximity schedule to the collars (see
5.1.8 Send Proximity Schedule). For details on how to select a collar and send the command,
refer to 5.1.5.1 Send GSM Schedule via GSM.
Figure 130: Dialog for configuring the Proximity Frequency command via GSM
5.3.7 Iridium Remote Configuration
These commands are equivalent to the commands in 5.3.6 GSM Remote configuration, but
apply for Iridium collars. In the Destination Collar(s) list, collars are selected by IMEI, not by
phone number.
5.3.8 Edit Virtual Fence
This command is the same as 4.4.9 Edit Virtual Fence. See this chapter for instructions on
how to edit virtual fences.
5.3.9 Send Virtual Fence
5.3.9.1 Send via GSM
With this command, you can send a Virtual Fence Collection and an associated GPS schedule
to multiple GSM collars. Just select those collars in the Destination Collars List which you
want to receive the fence, select a Virtual Fence Collection (.VFC) and a GPS schedule, and
click Send . The program will send the virtual fence to all selected collars successively.
Invalid fences or schedules prevent the transmission and are marked as such. Additionally, the
size of the virtual fence and the GPS schedule must be considerable smaller than when using
This design is the property of VECTRONIC Aerospace GmbH. Unauthorized duplication or distribution to a third party is prohibited.
VECTRONIC Aerospace 134 /235 Manual_GPS-Plus-Collar-Manager-V3.11.3.docx