Solar Power Kit (#6610) - Davis Instruments Corp.

Mounting the Solar Power Kit on a Post1. With a 3/16” (5 mm) drill bit, drill two holes approximately 2" (50 mm)apart. Use a carpenter’s level to ensure the holes will be level.2. Drill two more holes 7-1/32”below the upper holes.3. Insert the 1/4” x 1-1/2” lagLagscrews through the flat washers,Flat Screwand through the holes atWasherthe top of the shelter into thepost.Using an adjustable wrenchor 7/16” wrench, tighten thelag screws.4. Insert the 1/4” x 1-1/2” lagscrews through the flat washers,and through the holes atthe bottom of the shelter into the post.Mounting Solar Power Kit on a PostUsing an adjustable wrench or 7/16” wrench, tighten the lag screws.Connecting Power to the Vantage Pro Console1. The Solar Power Kit’s connector plugs directly into the power jack locatedon the bottom of the Vantage Pro Console. See your Vantage Pro ConsoleManual for details.2. Secure the power cable run using the included 8” cable ties.TroubleshootingWhile the Solar Power Kit is designed to provide years of trouble-free operation,occasional problems may arise. If you experience a problem, please checkthe troubleshooting tips below before calling technical support.✦Solar panel fails to power station and battery is over 5 years oldAs the battery ages, it will lose capacity and may completely discharge.If this is the case, simply replace the battery.CAUTION:Do not incinerate the used battery; it may burst. Arrange for proper recycling in yourlocality.✦Solar panel fails to power station and battery is less than 5 years oldIf the solar kit fails to power the station, try the following:1. Make sure the panel is not being shaded from the sun.2. Open the solar panel shelter and check that the wire connectionsare secure and that battery is free from corrosion and excessivedeposits on the terminal.Mounting the Solar Power Kit on a Post Page 3