ONE300 Installation Manual - OneAccess extranet
ONE300 Installation Manual - OneAccess extranet ONE300 Installation Manual - OneAccess extranet
5.3 ConnectionThe external power supply is connected on the rear panel of the device.The external power supply is delivered with the router package.• Connect the ’jack’ connector of the external power supply to the DC “12V –2,2A” power input device connector,• Connect the DC input jack from the power supply to the DC “12V-2,2A” powerinput on the rear panel of the router,• Secure the power supply connection by installing the DC power supply cordinto the plastic ring.The device shall not be used with another power supply than a powersupply provided by OneAccess.26ONE300 – Installation Manual
6 Power-upTo power up the device, always follow these steps:• Connect the DC power input jack from the power supply to the DC powerinput of the rear panel of the router,• Connect the power supply to the AC mains (100-240 V AC).The connection of the power supply causes the switch-on of the equipment.Few seconds after power-on, the device performs a series of self-tests and loadsthe software into memory (RAM), during which the ’STATUS’ LED on the frontpanel blinks:• The ’STATUS’ LED light remains steady green if software initialization wassuccessful,• The ’STATUS’ LED blinks in case of software absence or error duringsoftware loading.Refer to the Software and ONEOS User Guide for more information.ONE300 – Installation Manual27
- Page 1 and 2: ONE300Installation ManualVersion BA
- Page 3 and 4: How to Read this ManualThe present
- Page 5 and 6: 1 Safety InstructionsThe following
- Page 7 and 8: 2 Directives and Standards2.1 Decla
- Page 9 and 10: 3 Router Description3.1 Hardware De
- Page 11 and 12: 3.3 Rear PanelThis section details
- Page 13 and 14: 3.3.2 Configuration with 1 PRIThe i
- Page 15 and 16: 4 Interface Description4.1 G.SHDSL
- Page 17 and 18: 4.3 LAN 10/100 Mbps interface (ETHE
- Page 19 and 20: 4.5 ISDN PRI Interface (PRI)This in
- Page 21 and 22: The drawing below presents the posi
- Page 23 and 24: Configuration with impedance adapta
- Page 25: 5.2 Extension BoardThe installation
- Page 29 and 30: 8 Directives and Standards8.1 Decla
- Page 31 and 32: TelecomITU-T K21 on G.SHDSL(2003-07
5.3 ConnectionThe external power supply is connected on the rear panel of the device.The external power supply is delivered with the router package.• Connect the ’jack’ connector of the external power supply to the DC “12V –2,2A” power input device connector,• Connect the DC input jack from the power supply to the DC “12V-2,2A” powerinput on the rear panel of the router,• Secure the power supply connection by installing the DC power supply cordinto the plastic ring.The device shall not be used with another power supply than a powersupply provided by <strong>OneAccess</strong>.26<strong>ONE300</strong> – <strong>Installation</strong> <strong>Manual</strong>