MSDS - STOKO Skin Care
MSDS - STOKO Skin Care MSDS - STOKO Skin Care
Material Safety Data SheetProduct Name: STOKO Refresh® Mild Liquid HandwashMSDS ID: SK-118C* * * Section 4 - First Aid Measures * * *First Aid: EyesIn case of contact, immediately flush eyes with large amounts of water, continuing to flush for 15 minutes. Ifirritation persists get medical attention.First Aid: SkinIntended as a cosmetic hand cleaner. Non-toxic.First Aid: IngestionNon-toxicFirst Aid: InhalationIf symptoms are experienced, remove source of contamination or move victim to fresh air.General Fire HazardsNone.* * * Section 5 - Fire Fighting Measures * * *Upper Flammable Limit (UFL): Not determinedLower Flammable Limit (LFL): Not determinedMethod Used: PMCCFlash Point: N/AFlammability Classification: Not FlammableAuto Ignition: Not determinedHazardous Combustion ProductsNone identified.Extinguishing MediaDry chemical, foam, carbon dioxide, water fog.Fire Fighting Equipment/InstructionsFirefighters should wear self-contained air supplied breathing apparatus in enclosed areas or in areas of heavysmoke or fumes.NFPA Ratings: Health: 1 Fire: 0 Reactivity: 0Hazard Scale: 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Severe* * * Section 6 - Accidental Release Measures * * *Containment ProceduresAbsorb spill with inert material.Clean-Up ProceduresAbsorb spill with inert material. Shovel material into appropriate container for disposal. Flush small residuals tothe drain for normal biological wastewater treatment.Evacuation ProceduresNone.Special ProceduresNone.____________________________________________________________Page 2 of 5 Issue Date: 10/24/2012 Revision: 2.0000 Print Date: 10/24/2012
Material Safety Data SheetProduct Name: STOKO Refresh® Mild Liquid HandwashMSDS ID: SK-118C* * * Section 7 - Handling and Storage * * *Handling ProceduresKeep container closed. See container label for proper use.Storage ProceduresAvoid storage in extreme heat or cold.* * * Section 8 - Exposure Controls / Personal Protection * * *Exposure GuidelinesA: General Product InformationFDA regulated. For OSHA workplace hazards, investigate and read and understand component MSDS’s beforemanufacturing.B: Component Exposure LimitsNo information is available.Engineering ControlsNone necessary.PERSONAL PROTECTIVE EQUIPMENTPersonal Protective Equipment: Eyes/FaceAvoid eye contact.Personal Protective Equipment: SkinNone.Personal Protective Equipment: RespiratoryNot required for product end use.Personal Protective Equipment: GeneralObey reasonable safety precautions and practice good housekeeping.* * * Section 9 - Physical & Chemical Properties * * *Appearance: Clear green Odor: AromaticPhysical State: Liquid pH: 5.0 – 6.0Vapor Pressure: Not established Vapor Density: 212º F Melting Point: 32º FSolubility (H2O): Miscible in water Specific Gravity: 1.02 g/cc 3Evaporation Rate:
Material Safety Data SheetProduct Name: <strong>STOKO</strong> Refresh® Mild Liquid Handwash<strong>MSDS</strong> ID: SK-118C* * * Section 4 - First Aid Measures * * *First Aid: EyesIn case of contact, immediately flush eyes with large amounts of water, continuing to flush for 15 minutes. Ifirritation persists get medical attention.First Aid: <strong>Skin</strong>Intended as a cosmetic hand cleaner. Non-toxic.First Aid: IngestionNon-toxicFirst Aid: InhalationIf symptoms are experienced, remove source of contamination or move victim to fresh air.General Fire HazardsNone.* * * Section 5 - Fire Fighting Measures * * *Upper Flammable Limit (UFL): Not determinedLower Flammable Limit (LFL): Not determinedMethod Used: PMCCFlash Point: N/AFlammability Classification: Not FlammableAuto Ignition: Not determinedHazardous Combustion ProductsNone identified.Extinguishing MediaDry chemical, foam, carbon dioxide, water fog.Fire Fighting Equipment/InstructionsFirefighters should wear self-contained air supplied breathing apparatus in enclosed areas or in areas of heavysmoke or fumes.NFPA Ratings: Health: 1 Fire: 0 Reactivity: 0Hazard Scale: 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Severe* * * Section 6 - Accidental Release Measures * * *Containment ProceduresAbsorb spill with inert material.Clean-Up ProceduresAbsorb spill with inert material. Shovel material into appropriate container for disposal. Flush small residuals tothe drain for normal biological wastewater treatment.Evacuation ProceduresNone.Special ProceduresNone.____________________________________________________________Page 2 of 5 Issue Date: 10/24/2012 Revision: 2.0000 Print Date: 10/24/2012
Change language