Chauvet Colorado 1 Tri IP Manual - EES

SetupMountingOrientationRiggingBefore mounting this fixture, read and follow the safety recommendations indicated inthe Safety Notes section (page 2 of this manual).Always mount this fixture in any safe position while making sure that there is adequateroom around it for ventilation, configuration, and maintenance.Make sure to mount this fixture away from any flammable material as indicated in theSafety Notes section.The COLORado 1-Tri IP consists of a sealed (IP66) housing with a double bracketmounting yoke. It has two DMX signal cables (DMX In/DMX Out), and two power cables(Power In/Power Out), all of them fitted with proprietary IP66 connectors.CHAUVET® recommends following the general guidelines below when mounting theCOLORado 1-Tri IP.• When selecting an installation location, consider ease of access to the fixture foroperation, programming adjustments, and routine maintenance.• If hanging this fixture, make sure that the location where you are mounting thefixture can support its weight. Please see the Technical Specifications section of thismanual for the weight requirement of this fixture.ProcedureThe COLORado 1-Tri IP includes a safety cable and a mounting yoke to which youcan attach one or two rigging clamps. You must supply your own “C” or “O” clamps andmake sure that they are capable of supporting the weight of this fixture. Although it ispossible to use a single clamp per fixture, CHAUVET® recommends using two clampsper fixture. Secure the fixture with the safety cable after mounting it to the truss.C clamp(not included).Product MountingDiagramFloor MountingSecure the safety cable usingthe passageway on the backof the fixture.Overhead Mounting-8- COLORado 1-Tri IP User Manual Rev. 01c