On-The-Vehicle - aesco

On-The-VehicleBefore You BeginThe AMMCO ® 800 On-The-Vehicle Brake Lathe isintended to resurface the disc brake rotors on passengercars, RV, and up through 1-ton trucks. Usingthis lathe for other purposes could result in personalinjury and/or equipment damage; therefore noattempt will be made to identify all uses for which thislathe is not intended.Receiving1.0 The shipment should be thoroughly inspectedas soon as it is received. The signed bill of lading isacknowledgement by the carrier of receipt in goodcondition of shipment covered by our invoice.If any of the goods called for on this bill of lading areshorted or damaged, do not accept them until the carriermakes a notation on the freight bill of the shortedor damaged goods. Do this for your own protection.NOTIFY THE CARRIER AT ONCE if any hidden lossor damage is discovered after receipt and request thecarrier to make an inspection. If the carrier will not doso, prepare a signed statement to the effect that youhave notified the carrier (on a specific date) and thatthe carrier has failed to comply with your request.IT IS DIFFICULT TO COLLECT FOR LOSS OR DAM-AGE AFTER YOU HAVE GIVEN THE CARRIER ACLEAR RECEIPT.File your claim with the carrier promptly. Supportyour claim with copies of the bill of lading, freight bill,invoice, and photographs, if available.Although AMMCO’s responsibility ceases upondelivery of the shipment to the carrier, we will gladlyassist in tracing lost shipments. Our willingness toassist in every possible manner does not makeAMMCO responsible for collection of claims orreplacement of lost or damaged materials. Shippingdamage claims will not be handled under warranty.Electrical Requirements2.0 The lathe must be properly grounded to protectthe operator from shock. The lathe is equipped with anapproved 3-conductor cord and a 3-prong groundingtype plug to fit the proper grounding-type receptacle.Should an extension cord be required, use 3-conductorcords with 3-prong grounding plug and 3-pronggrounding receptacle properly rated to handle thiselectrical power tool only. Do not modify a cord or plugto match a receptacle; have a qualified electricianinstall an appropriate outlet to match the lathe requirements.Repair or replace any worn or damaged powercords immediately.2.1 Verify that the lathe plug and grounding-typereceptacle match.CAUTIONPlug and Receptacle Should MatchAMMCO 800 On-The-Vehicle Brake Lathe • 1