On-The-Vehicle - aesco

More documents

Recommendations

Info

On-The-VehicleRemoving the Lathe13.0 After the refinishing process is complete andthe cutting tips are clear of the rotor, disengage thefeed engagement knob (gray).13.3To remove the 800 brake lathe from the vehicle,loosen the adjustment knobs (red and blue) to the topposition to reduce the drawbar tension. This will allowthe drawbar to be loosened and withdrawn easily.13.1 Switch the power OFF and remove the powercord from the twist-lock receptacle.13.4 Disconnect the 800 brake lathe by disengagingthe drawbar from the hub adapter using the drawbarstar knob (black).13.2 Use the motor handwheel to rotate the spindlemanually, to position the adjustment knobs (redand blue) at the start position, and insert the lock pin(yellow) into the runout adjustment head.18 • AMMCO 800 On-The-Vehicle Brake Lathe
On-The-Vehicle13.5 Inspect the rotor after machining to verify thatthe rotor runout and thickness meet manufacturer’sspecifications.13.6 Remove the chatter band and hub adapter.Setup for Opposite Side Vehicle RotorResurfacing14.0 To cut the brake rotor on the opposite side ofmost vehicles, the 800 brake lathe most be rotated toits inverted position. To invert the lathe loosen thepivot-locking lever on the portable stand system.Adjust to an angular position, as done for the firstrotor, to assure lathe clearance during the refinishingprocess, then tighten the pivot-locking lever.14.1 Rotate the spindle manually, using the motorhandwheel, to position the adjustment knobs (red andblue) to the up position, and insert the lock pin (yellow)into the runout adjustment head.14.2 After the 800 brake lathe has been attachedto the vehicle, it is not necessary to center the cuttinghead assembly as that was accomplished on the firstrotor.AMMCO 800 On-The-Vehicle Brake Lathe • 19
Page 1 and 2: Safety Instructions Pgs. iii-viInst
Page 3 and 4: Owner’s ResponsibilityTo maintain
Page 5 and 6: Safety Notices and DecalsFor your s
Page 7 and 8: On-The-VehicleBefore You BeginThe A
Page 9 and 10: On-The-VehicleStandard AccessoriesP
Page 11 and 12: On-The-Vehicle800 On-The-Vehicle Br
Page 13 and 14: On-The-Vehicle3.6 Remove the valve
Page 15 and 16: On-The-Vehicle5.4 Now practice usin
Page 17 and 18: On-The-VehicleOperating Instruction
Page 19 and 20: On-The-VehicleLathe to Vehicle Atta
Page 21 and 22: On-The-VehicleAdjusting the Lathe R
Page 23: On-The-VehicleThe mirror maybe used
Page 27 and 28: On-The-VehicleAdjustment KnobReposi

On-The-Vehicle - aesco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?