nsn 6115-00-033-1395 - Igor Chudov

TM 5-6115-631-14&P(7)(8)(9)(10)(11)(12)(13)(14)(15)(16)Insert one lifting ring (17) into each of two mounting holes in trailer body (13) and securewith one flat washer (16) and one nut (15). Install one cotter pin (14) in each nut (15) andspread cotter pin ends.Position two generator set mounting rails (12) on trailer body (13). Insert eight screws (9)with eight flat washers (10) through each mounting rail and through trailer bed andframe (22).Working under trailer, install one flat washer (10) and one nut (11) on each of 16 mountingrail screws (9) and tighten.Position one composite light (5) on each rear mounting bracket (8) and secure each lightwith two screws (6) and two Iockwashers (7).Working under trailer, connect one composite light cable assembly (3) to each compositelight (5) by plugging four cable assembly connectors into four composite light connectors(4). Plug four connectors at opposite end of each cable assembly into four connectors (1)on trailer main wiring harness (2).Install both generator sets (paragraph 5-7, b.).Install switch box (paragraph 4-24, b.).Install accessory box (paragraph 4-19, b.).Install six bows (paragraph 3-11, b(2)).Install fitted cover (paragraph 3-11, a(2)).5-4. Fitted Cover Repair. Repairs to the fitted cover shall be made in accordance with FM 10-16.,Fabric Repairing.5.5. Accessory Box Repair. (See figure 5-4.) The accessory box is repaired by replacing the hasp,the catches and the footmans loops, as required. The box itself may be straightened, welded, andrepainted. If required, repaint in accordance with MIL-T-704, Type F, color Green, No. 383 of MIL-C-46168.a. Catch and Hasp Replacement.(1) Grind off or drill out solid rivets (1, figure 5-4) securing catch or hasp (2) to accessorybox (3).(2) Position new catch or hasp (2) on accessory box and secure with solid rivets (1).(3) Touch up with paint as required.5-7