nsn 6115-00-033-1395 - Igor Chudov

TM 5-6115-631-14&PCHAPTER 5INTERMEDIATE (FIELD), DIRECT SUPPORTAND GENERAL SUPPORT MAINTENANCE INSTRUCTIONSSection I. INTRODUCTION5-1. General. This chapter contains Intermediate Direct Support and General Support level maintenanceprocedures for components of the AN/MJQ-16 Power Plant which are not part of the basicgenerator sets or trailer. For all other intermediate direct and general support maintenance procedureson the trailer, refer to TM 9-2330-213-14&P. For intermediate direct and general supportmaintenance procedures on the generator set, refer to TM 5-6115-584-34.WARNINGBefore performing any maintenance that requires climbing on or under trailer,set trailer handbrakes, chock wheels and lower rear leg prop. Injury topersonnel could result from trailer suddenly rolling or tipping.Section Il. MAINTENANCE OF POWER PLANT TRAILER5-2. Leg Prop Assembly Maintenance. Maintenance of the leg prop assembly at the IntermediateDirect Support and General Support level consists of repairing or replacing the assembly as required.a. Leg Prop Assemb/y Replacement. (See figure 5-1.)(1) Remova/.(a)(b)(c)(d)While supporting leg prop assembly, pull out angled bar (1, figure 5-1) and lower legfrom traveling position.Line up boss (2) on upper leg (3) with holes in bracket (4) and insert angled bar (1) tolock leg in support position.Remove either one of two cotter pins (5) from leg prop assembly pivot shaft (6).While steadying leg prop assembly, remove shaft (6) with remaining cotter pin (5) inplace.WARNINGWhen angled bar is removed in step (e), leg prop assembly will fall frombracket if not supported. To prevent injury to personnel or damage toequipment, do not permit leg assembly to drop.(e)(f)(g)Lift leg assembly slightly to take weight off angled bar (1) and remove bar.Lower leg assembly from bracket (4).Remove three screws (7), three flat washers (8), three Iockwashers (9) and three nuts(10) and remove bracket (4) from trailer frame (11).5-1