Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
TM 5-<strong>6115</strong>-631-14&PWARNINGBefore performing any maintenance that requires climbing on or under trailer,set trailer handbrakes, chock both wheels, and lower rear leg prop. Injury topersonnel could result from trailer suddenly rolling or tipping.4-18. Fuel Can Bracket Replacement. (See figure 4-4.) There are four fuel can brackets supplied ,,with the AN/MJQ-16. Two brackets are mounted on top of each fender. Replacement proceduresdescribed below are typical for all four.a. Removal.Figure 4-4. Fuel Can Bracket Replacement.(1) Remove four screws (1, figure 4-4), four nuts (2) and four flat washers (3) securingbracket (4) to fender (5).(2) Remove bracket (4) from fender (5).b. Installation..(1) Position fuel can bracket (4) on fender (5).(2) Insert four screws (1) down through bracket (4) and through fender (5).(3) Install one washer (3) and one nut (2) on each screw (l). Tighten hardware to securebracket (4).4-19. Accessory Box Replacement. (see figure 4-5.) The power plant is equipped with an accessorybox which is mounted to the trailer bed between the front and rear generator sets.4-15
Change language