nsn 6115-00-033-1395 - Igor Chudov

TM 5-6115-631-14&PTable 4-2. Troubleshooting – CONT.MalfunctionTest or inspectionCorrective action3. ONE OR BOTH INDICATOR LIGHTS FAIL TO LIGHT WHEN ASSOCIATED GENERATOR SET ISOPERATING AND ROTARY SWITCH IS SET TO “ON ” POSITION FOR THAT GENERATOR.Step 1.Check if bulb is defective.If bulb is defective, replace.Step 2.Check wires inside switch box associated with non-functioning light for loosenessor broken wire terminals.Tighten loose connections. If any terminals are broken, replace wire(s)(paragraph 4-25, c.) or refer to higher level of maintenance for repair.Step 3.Perform continuity check on wires associated with non-functioning indicator(paragraph 4-23, b.(3) or (4), as applicable).If wires are defective, replace indicator light and wire assembly(paragraph 4-25, b.).Step 4.Perform continuity check on indicator housing (paragraph 4-23, b.(3) or (4),as applicable).If housing is defective, replace indicator light and wire assembly(paragraph 4-25, b.).Section VII. RADIO INTERFERENCE SUPPRESSION4-15. General Methods Used to Attain Proper Suppression. Essentially, suppression is attained byproviding a low resistance path to ground for stray currents. The methods used include shieldingignition and high-frequency wires, grounding the frame with bonding straps, and using filteringsystems.4-16. Radio Interference Suppression Components. All component parts of the power plant enditem, whose primary or secondary function is radio interference suppression, are on the generatorsets. Refer to TM 5-6115-584-12 for location of radio interference suppression components.Section VIII. MAINTENANCE OF POWER PLANT TRAILER4-17. General. This section of the manual contains unit level maintenance procedures forcomponents of the M103A3 trailer added when the trailer is used as part of the AN/MJQ-16 powerplant. These components are not covered in the overall trailer maintenance manual. For all other unitmaintenance procedures on the trailer, refer to TM 9-2330-213-14&P.4-14