nsn 6115-00-033-1395 - Igor Chudov

TM 5-6115-631-14&Pi. Attach power unit to towing vehicle. (Refer to TM 9-2330-213-14&P.)4-4. Reinstallation After Movement. After movement to a new worksite, install power plant inaccordance with paragraph 4-2.Section Ill. REPAIR PARTS, SPECIAL TOOLS, SPECIAL TEST, MEASUREMENT ANDDIAGNOSTIC EQUIPMENT (TMDE)4-5. Tools and Equipment. There are no special tools or equipment required to maintain theAN/MJQ-16 power plant.4-6. Maintenance Repair Parts. Repair parts and equipment for maintenance of this power plant arelisted and illustrated in the repair parts and special tools list in Appendix D of this manual.Section IV. LUBRICATION INSTRUCTIONS4-7. General. Detailed instructions for the lubrication of the major components of the power plant arecontained in the applicable Lubrication Orders (LO’s). Refer to DA Pam 25-30 to ensure that the latesteditions of the L.O.’S are used. This section contains lubrication instructions that are not included inthe Lubrication Orders.4-6. Generator Lubrication. Refer to LO 5-6115-584-12 for generator set Lubrication Order.4-9. Trailer Assembly Lubrication.a. Trailer Lubrication. Refer to TM 9-2330-213-14&P for trailer Lubrication Order.b. Leg Prop Assembly Lubrication. The rear leg prop assembly is a modification to the standardM103A3 trailer and, as such, does not appear in the associated L.O. Semiannually lubricate leg propassembly as follows:WARNINGClean parts in a well-ventilated area. Avoid inhalation of solvent fumes andprolonged exposure of skin to cleaning solvent. Wash exposed skin thoroughly.Dry cleaning solvent (P-D-680) used to clean parts is potentiallydangerous to personnel and property. Do not smoke or use near open flame orexcessive heat. Flash point of solvent is 100°F. to 138°F. (38°C. to 59°C.).(1) Clean hydraulic lubrication fitting and area around lubrication points with P-D-680 orequivalent.(2) Inject sufficient GAA grease into hydraulic fitting to lubricate screw theads inside leg propassembly.NOTERefer to Lubrication Instructions in TM 9-2330-213-14&P for lubricating oilsspecified for use within different anticipated temperature ranges.(3) Apply OE lubricating oil to both ends of leg prop assembly pivot shaft.4-7