WAREMA Mobile System® WMS Central transmitter

Getting startedGCurrent settings of the parameters shown to the leftThis display only appears in the parameter menus. The function buttons tothe right of values that cannot or may not be changed are not active.Cursor lineThe coloured cursor line indicates which menu line is currently selected. Thearrow buttons on the left can be used to move the cursor line up or down.Press ok to activate the selected menu line.Right function button fieldThis grey field shows the functions of the buttons next to it. The buttons canhave different functions depending on the menu and the selected menu line.The function buttons on the right side are primarily used to operate products,activate functions and enter parameters.6.1.1 Status displayThe symbols in the header indicate the following states of the WMS:Charge status (green symbol)The number of segments indicates the charge status. The segments areswitched on and off during charging ( )Low charge status (red symbol)Place the WMS Central transmitter into the charging station for chargingsoon.Batteries nearly depleted (red symbol)Place the WMS Central transmitter into the charging station for charging.Bad batteries (red symbol)The batteries are faulty or too old. Replace the batteries with new original rechargeablebatteries.NOTEIf you have commercially-available batteries in the device and place the deviceinto the charging station, this symbol appears after some minutes. Thecharging controller has detected the batteries and stopped charging. Whenoperating the device with regular batteries, you do not need to put it into thecharging station. We recommend using the supplied rechargeable batteriesbecause regular batteries have a short life.No batteries insertedInsert the supplied batteries into the device (see Chapter 3.3 on page 14).Dealer modeThis symbol appears while you are logged in as the specialist dealer.Transmission activeThis symbol is displayed while the central transmitter is executing a transmission.Green symbol: The central transmitter is transmitting.Red symbol: The central transmitter did not receive a response from thereceiver.890405_0•en•01.11.2009 We reserve the right to carry out improvements 31