WAREMA Mobile System® WMS Central transmitter

CommissioningCAUTIOThe plastic feet of the device may leave marks on sensitive surface suchas on furniture. Modern furniture is coated with a variety of surface finishesthat can be treated with a selection of care products. Some of these agentsmay contain substances that corrode or soften the plastic feet of the device.Plastic feet that have been damaged in this way may leave marks onfurniture. Use a non-slip mat to prevent surface damage.3.2.2 Charging station as a wallsupportIf you wish to install the charging station on the wall, it is not necessary to attachthe base to the charging station.Use the included screws and dowels to install the charging station on a flat,vertical surface.The following points must be observed:Select an installation location close to a power socket. The power supply unitcable should not be taut. Ensure that no one can trip on the cable.Do not erect the unit outdoors, close to heat sources (heater, fireplace, etc.)or in direct sunlight.Choose an installation height that permits convenient reading of the display(recommended: bottom edge of the device approx. 1.35 m above floor level).The two screws must be level.The charging station must be secure after it is attached.124 mmFig. 2Charging station as a wall supportPlug the connector of the external power supply unit into the socket on thebottom of the charging stationPlug the external power supply unit into a power socket.The charging station is now ready for operation.890405_0•en•01.11.2009 We reserve the right to carry out improvements 13