WAREMA Mobile System® WMS Central transmitter

CommissioningWAREMAWMS Central transmitter3 Commissioning3.1 Scope of delivery3.2 Charging stationThe WMS Central transmitter is ready for operation after only a few steps.The box contains the following parts:WMS Central transmitterCharging station (two parts). With the separate base, the station can be usedon a table or as a wall support.External power supply unit for charging station (100 to 240 V AC, for useworldwide)Microfibre cloth for gentle cleaning of the acrylic glass surfaceTwo screws and two dowels for mounting the charging station on the wall, ifdesiredTo operate the WMS Central transmitter, you can hold it in your hand or leaveit in the charging station. The charging station can be used on a table or asa wall support.CAUTIOThe WMS Central transmitter and charging station are for indoor use only. Donot erect or install the products outdoors.3.2.1 Charging station as atable standIf you wish to use the charging station as a table stand, connect the twoparts of the charging station as shown until they engage.Fig. 1Charging station as a table standPlug the connector of the external power supply unit into the socket on thebottom of the charging stationPass the cable through the two slots to the back of the charging station.Observe the following points when erecting the unit:Position the charging station on a level surface close to a power socket. Thepower supply unit cable should not be taut. Ensure that no one can trip onthe cable.Do not erect the unit outdoors, close to heat sources (heater, fireplace, etc.)or in direct sunlight.Plug the external power supply unit into a power socket.The charging station is now ready for operation.12We reserve the right to carry out improvements890405_0•en•01.11.2009