WAREMA Mobile SystemÃ‚Â® WMS Central transmitter

More documents

Recommendations

Info

SystemWAREMAWMS Central transmitterButtonAction/resultEnter the serial number of the device.(For entering texts, see also Chapter 6.4 on page 35).Press the button to learn out the device.The following message appears.Press the ok button and check whether all devices wave. Youcan press the ok button as often as necessary.Leave the menu using the button when you are sure thatall network devices confirmed the delete command by waving.The Commissioning menu opens again.106We reserve the right to carry out improvements890405_0•en•01.11.2009
System9.2.4 Loading the factorysettingsThis function can be used to reset the central transmitter to the factory settingswhen needed. After this, extensive commissioning work will be to setup the central transmitter again.CAUTIOThis deletes the central transmitter from the network. If there are no furthertransmitters in the network, the central transmitter cannot be added to thenetwork. In this case, the WMS network needs to be fully re-commissioned.Proceed as follows to load the factory settings.Main menu System Commissioning Load factory settingButtonAction/resultIn the main menu, select the [System] menu and press ok.The [System] menu opens.Select the [Commissioning] menu here and press ok.The [Commissioning] menu opens.Using the selection cursor, select the[Load factory settings] menu item.Call up the function with ok.The following menu is displayed.Press the ok button to reset the central transmitter.The central transmitter restarts completely after a fewseconds. Wait for the start procedure to finish and the mainmenu to be displayed again.890405_0•en•01.11.2009 We reserve the right to carry out improvements 107
Page 1 and 2:
WAREMA Mobile System ®WMS Central
Page 3 and 4:
ContentsContents1 Legal notes......
Page 5 and 6:
Contents9.2.4 Loading the factory s
Page 7 and 8:
IntroductionCongratulations on choo
Page 9 and 10:
Safety instructions2.2 Intended use
Page 11 and 12:
Safety instructions2.5 Working safe
Page 13 and 14:
CommissioningCAUTIOThe plastic feet
Page 15 and 16:
Introduction4 IntroductionThe WMS C
Page 17 and 18:
Introduction4.2 Menu elementsAn ove
Page 19 and 20:
Introduction4.2.2 Product type disp
Page 21 and 22:
IntroductionProduct typeAwning with
Page 23 and 24:
Introduction4.4.5 FavouritesAny des
Page 25 and 26:
Menu structure4.5 Sleep modeThe WMS
Page 27 and 28:
Getting started5.2 ProductsCopy cha
Page 29 and 30:
Getting started5.4 System (part 2)L
Page 31 and 32:
Getting startedGCurrent settings of
Page 33 and 34:
Getting started6.3 Example for oper
Page 35 and 36:
Getting started6.4 Operating exampl
Page 37 and 38:
Getting started6.5.2 Operating a pr
Page 39 and 40:
Favourites7 FavouritesYou will oper
Page 41 and 42:
FavouritesButtonAction/resultOperat
Page 43 and 44:
Favourites7.1.3 Operating products
Page 45 and 46:
Favourites7.3 Managing favouritesTo
Page 47 and 48:
Favourites7.3.2 Selecting an iconTo
Page 49 and 50:
Favourites7.3.4 Allocating a channe
Page 51 and 52:
Favourites7.3.6 Deleting a favourit
Page 53 and 54:
FavouritesButtonAction/resultUsing
Page 55 and 56: FavouritesButtonAction/resultUsing
Page 57 and 58: FavouritesButtonAction/resultUsing
Page 59 and 60: Products8.1 Operating theproducts8.
Page 61 and 62: Products8.1.3 Operating products by
Page 63 and 64: ProductsButtonAction/resultUsing th
Page 77 and 78: System9.1 ProductsNOTEVia the [Prod
Page 79 and 80: System9.1.2 Calling up channelinfor
Page 81 and 82: System9.1.3 SettingsThis menu gives
Page 83 and 84: System9.1.3.1 Basic functionsMain m
Page 85 and 86: SystemMenu itemSwitch-off delaySett
Page 87 and 88: SystemMenu itemSlat angle, warm -18
Page 89 and 90: System9.1.3.12 ScenesMain menu Syst
Page 91 and 92: System9.1.3.15 Sensor allocationMai
Page 93 and 94: System9.1.4 Move command faultsFor
Page 95 and 96: System9.1.6 Actuators in the channe
Page 97 and 98: SystembuttonAction/resultUsing the
Page 99 and 100: SystemNOTEIf you wish to learn in a
Page 101 and 102: System9.2.2 Learning hand-heldtrans
Page 103 and 104: SystemButtonAction/resultUsing the
Page 105: System9.2.3 Learning out actuators/
Page 109 and 110: SystemButtonAction/resultLeave the
Page 111 and 112: SystembuttonAction/resultPress the
Page 113 and 114: System9.3.2 Setting the date and ti
Page 115 and 116: System9.3.3 Adjusting the backgroun
Page 117 and 118: System9.4 Specialist dealerNOTEIn t
Page 119 and 120: System9.4.3 Changing the specialist
Page 121 and 122: Technical data10 Technical dataWARE
Page 123 and 124: Notes890405_0•en•01.11.2009 We
show all

WAREMA Mobile SystemÃ‚Â® WMS Central transmitter

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?