CENTRAL MARKS DEPARTMENT – II Our Ref: CMD-II/16 ... - BIS

e) Control Unit number;f) Any other marking required by the buyer; andg) Licence No. (CM/L- ……………….)5. Identification and Packing – If the agreement between the buyer and seller soprovides ropes shall be marked for identification of grade in accordance with theprocedure laid down in IS 9560:1980 as given 10.1 of IS 1084:2005. In thisregards clause 10.1.1 of IS 1084:2005 shall also be satisfied. Unless otherwisespecified, ropes shall be packed confirming to the requirements laid down in IS3256.6. Control Unit – For the purpose of this scheme, all the coils of rope of one type(refer clause 1 of IS 1084:2005), grade (refer Clause 4 of IS 1084:2005) anddiameter manufactured in a day under similar condition shall constitute a controlunit.7. Levels of Control – The analysis and tests as indicated in Table 1 and at levels ofcontrol specified therein shall be carried out on the whole production of the factorycovered by the scheme and appropriate records and charts maintained inaccordance lwith clause 2.0 above. All the production which conforms to theIndian Standard and covered by this licence shall be marked with CertificationMark of the Bureau.7.1 Each of the sample drawn from a control unit as per the levels of control laid downin Table 1 and tested shall satisfy the requirements of the specification as laid down.7.1.1 If any sample fails in respect of a given requirement all the coils of ropes in thecontrol unit shall be subjected to testing. In case of failure, the defectives sofound shall be suitably corrected, if possible but shall be accepted for markingonly after retesting.8. In respect of all other clauses of the specification and at all stages of manufacturethe factory shall maintain appropriate controls and checks to ensure that theirproduct conforms to the various requirements of those clauses.9. MANUFACTURE9.1 Manil Fibres – The fibre used shall conform to 6.1 of IS 1084:2005.9.2 Yarns – The yarn shall conform to 6.2 of IS 1084:20059.3 Strands – The strands shall conform to 6.3 of IS 1084:20059.4 Ropes – The number of strands in the rope and lay of rope, unless otherwisespecified shall be as given in 6.4 of IS 1084:2005.