Installation Instructions - Chris Alston's Chassisworks

More documents

Recommendations

Info

37. Install the coil-over shock between theupper and lower mounts WITHOUT thecoil spring installed.38. Place one shock spacer on each sideof the shock’s COM bearing. Thecounterbore of each spacer will seataround the end of the bearing sleeve.39. Slide a fl at washer over the1/2-20 x 2-1/2” hex bolt and insertit through the upper mount bracket,spacers, and shock bearing.40. Place a second fl at washer onto the boltfollowed by a locknut.SPACERS41. Tighten and torque to 55 lb-ft.16
42. The upper mount and coil-over shockare installed.43. Place one shock spacer on each side ofthe shock’s COM bearing, and align withthe billet lower shock mount.44. Secure the lower eye of the shock usinga 1/2” bolt and locknut.17
Page 4: 4DRIVER SIDE SHOWN
Page 7 and 8: 3. Jack the car up and place two ja
Page 9 and 10: 11. Bolt the upper coil-over mount
Page 11 and 12: 18. Align the top edge on the coil-
Page 13 and 14: 25. Remove the rear lower control a
Page 15: Before proceeding, the rearend hous
Page 19 and 20: 48. Once the clearance is checked y
Page 21 and 22: VERIFY RIDE HEIGHT (COIL-OVERS)Afte
Page 23 and 24: 1. Verify that the springs are supp

Installation Instructions - Chris Alston's Chassisworks

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?