Installation Instructions - Chris Alston's Chassisworks

37. Install the coil-over shock between theupper and lower mounts WITHOUT thecoil spring installed.38. Place one shock spacer on each sideof the shock’s COM bearing. Thecounterbore of each spacer will seataround the end of the bearing sleeve.39. Slide a fl at washer over the1/2-20 x 2-1/2” hex bolt and insertit through the upper mount bracket,spacers, and shock bearing.40. Place a second fl at washer onto the boltfollowed by a locknut.SPACERS41. Tighten and torque to 55 lb-ft.16