Installation Instructions - Chris Alston's Chassisworks

Before proceeding, the rearend housingmust be positioned to match the centerof-axleto fender-lip measurment takenearlier.33. Slide the billet shock mount into the coilovermount as shown. Measure from theupper coil-over mount shock hole down13-1/2”. This is the location of the billetshock mount hole at the shock’s centerof-travelheight.34. Move the billet mount to the closestposition to the 13-1/2” length.35. Secure the billet mount with the 3/8”bolts, aircraft washers, and locknutsprovided.36. Tighten the bolts and torque to 35 lb.-ft.15