Installation Instructions - Chris Alston's Chassisworks

More documents

Recommendations

Info

22. Secure the mount to the housing bracketwith a second 1/2-13 x 1-1/4” bolt, pairof fl at washers, and locknut. Torque bothbolts to 45 lb-ft.23. Drill a 5/16”-diameter hole through thecoil-over mount and housing bracket.24. Secure the mount with a5/16-18 x 1-1/4” bolt, fl at washers andlocknut. Torque to 25 lb-ft.12
25. Remove the rear lower control arm boltsat the rear end housing bracket.26. Slide the gusset bracket (7961-020)behind the lower coil-over mount andalong side the lower control bracket onthe housing.27. Bolt the gusset to the coil-over mountbracket with two 5/16-18 x 1-1/4” bolts,fl at washers and locknuts. DO NOT fullytighten the bolts at this time.28. Use the 1/2” fender washers as shims totake up any space between the gussetand the control arm mount.13
Page 4: 4DRIVER SIDE SHOWN
Page 7 and 8: 3. Jack the car up and place two ja
Page 9 and 10: 11. Bolt the upper coil-over mount
Page 11: 18. Align the top edge on the coil-
Page 15 and 16: Before proceeding, the rearend hous
Page 17 and 18: 42. The upper mount and coil-over s
Page 19 and 20: 48. Once the clearance is checked y
Page 21 and 22: VERIFY RIDE HEIGHT (COIL-OVERS)Afte
Page 23 and 24: 1. Verify that the springs are supp

Installation Instructions - Chris Alston's Chassisworks

Create successful ePaper yourself

Delete template?

Save as template?