EI ENGINE IMMOBILISER

EI–11ENGINE IMMOBILISER - ENGINE IMMOBILISER SYSTEMOK2 READ DATA USING DS-II (KEY SW)EI(a)(b)(c)Connect the DS-II to the DLC.Using the DS-II, following the prompts on the screen, select ECUDATA LIST and KEY SW.Check any changes in the switch condition (ON or OFF) when the keyis inserted to the ignition knob.StandardMeasurement ConditionScreenDisplayWhen the key is inserted to the ignition knobWhen the key is not inserted to the ignition knobONOFFNGREPLACE STEERING COLUMN UPPERWITH SWITCH BRACKET ASSEMBLYOK3 CHECK WIRE HARNESS AND CONNECTORSteering Column Upper With SwitchBracket AssemblyVehicle Side Connector(a)(b)Disconnect the steering column upper with switch bracket assemblyand combination meter assembly connectors.Using the tester, measure the continuity between terminals of theconnector on the vehicle side.StandardTerminal No. (Terminal Symbols)Steering Column Upper with Switch Bracket Assembly ←→Combination Meter AssemblyContinuity3 (-) ←→ 2 (B) Continuity(-)Combination Meter AssemblyNGREPAIR OR REPLACE WIRE HARNESS ORCONNECTORBB143230J01OK