Operating Instructions 150 000 032 02 US

Mounting3.5 Connecting the PTO Shaft• Swing the PTO shaft holder (2) upwards.• Slide PTO shaft (1) onto PTO end.• Prevent shaft protection with holding chain fromrotating with the shaft (wide angle at implement).A protective device must be used onthe tractor and the machine.Only the PTO shaft supplied may beused.12Look for the correct lenght of the PTOShaft by changing the tractor (s. cap.Lenght adaption)KS-0-0163.5.1 Length adaption• During all care, maintenance, repair and assembly work on the rotary swather, switch off thePTO. Shut down the engine, Remove the ignition key. Secure tractor and rotary swatheragainst rolling away!• Take apart the universal drive shaft.• Clip one half (1) and (2) onto the tractor and the otherto the implement.(The wide angle coupling must be installed on theimplement. Note the labeling on the universal driveshaft.)• Move the rotary swather to the position where theuniversal drive shaft is at its shortest. (headstocksteered up to the limit stop)• The rest of the procedure can be found in the manualprovided by the universal drive shaft manufacturer.12Check the slewing range and clearance forthe universal drive shaft! Contact betweenthe universal drive shaft and tractor orimplement will result in damage. (e.g.hitching device, draw bar)KS-0-017III - 6